Charging Time Usb Cord Computer; Using The Camera While Charging; Battery Storage And Handling; My Tactacam Won’t Power On - Tactacam 4.0 Quick Start Manual

Hide thumbs Also See for 4.0:
Table of Contents

Advertisement

WWW.TACTACAM.COM
WWW.TACTACAM.COM

CHARGING TIME USB CORD COMPUTER

The battery charges to 80% in approximately three hours and 100% in approximately four hours. When
using Tactacam's USB cord connected to computer for charging, it is best to have the camera Powered
off. Charge times may vary depending on your computer's USB output settings.

USING THE CAMERA WHILE CHARGING

Control the Tactacam 4.0 with Wi-Fi while the camera is plugged into a USB charging adapter, including
the Tactacam wall charger. (You cannot record while charging the camera through a computer.) Your
Tactacam 4.0, 3.0, and 2.0 can also capture video when connected to a USB external charging device.
Note: Because the back cap is off, the camera is not waterproof during charging.

BATTERY STORAGE AND HANDLING

The camera contains sensitive components, including the battery. Avoid exposing your camera to ex-
treme temperatures. Low or high temperature conditions may temporarily shorten the battery life or cause
the camera to temporarily stop working properly. Avoid dramatic changes in temperature or humidity
when using the camera, as condensation may form on or within the camera.
When storing your Tactacam, charge the battery so its 75% or higher. Remove the battery to eliminate
the possibility of internal corrosion. Replace the back cap to protect against dust and other unwanted
substances.
The removable battery in the camera is replaceable if your battery has failed. See Battery troubleshoot-
ing and other powering issues. www.tactacam.com/support
Do not dry the camera or battery with an external heat source such as a microwave oven or hair dryer.
Damage to the camera or battery caused by contact with liquid inside the camera is not covered under
the warranty.
Do not make any unauthorized alterations to the camera. Doing so may compromise safety, regulatory
compliance, performance, and will void the warranty.
FAQ's:
MY TACTACAM WON'T POWER ON
Make sure your Tactacam is charged. To charge your camera, use the included USB cable and a
computer or wall charger. See troubleshooting Your Camera: www.tactacam.com/support
13
TACTACAM.COM

Advertisement

Table of Contents
loading

This manual is also suitable for:

2.03.0

Table of Contents