Table of Contents
Advertisement
VIEWING EDITING & SHARING
WWW.TACTACAM.COM
• If sand or debris hardens around the back cap, soak the rear of the camera in warm tap water for 5 minutes and
then rinse thoroughly to remove the debris before opening.
• (4.0 and 3.0 ONLY) The camera is water-resistant no housing needed. Ensure that the back cap is closed and
locked before using the camera around water, dirt, or sand.
• For best audio performance, ensure the microphone hole is free of water or debris. To remove obstructions, shake
the camera or blow on the mic to remove water and debris from the microphone hole. *DO NOT stick anything in
the mic hole as you could damage the mic.
IMPORTANT MESSAGES / CAMERA VIBRATIONS (4.0 and 3.0 only)
If the camera begins to vibrate for 5 sec on and 5 seconds off repeatedly. Check the following:
NO SD CARD = The camera requires a microSD, microSDHC or microSDXC card to capture videos.
SD FULL = Delete files or swap card.
SD ERROR = Camera is unable to read card please format the card and try again. (See reformatting SD card
instructions).
NOTICE: When formatting SD cards and you select Yes, card's contents WILL BE DELETED. To avoid loss of video, down-
load all files onto your computer in a separate file. Reformat your microSD card on a regular basis to ensure that the card
can continue to receive information from the camera.
CAMERA BATTERY
Your camera and battery need to stay connected when operating. Do Not remove the battery from the camera
when in use or your data will be lost.
On your Tactacam 4.0 and 3.0 there are 4 Green LED battery indicator lights. When all 4 lights are illuminated the
camera battery is full. As the battery levels decreases the lights will begin to reduce in numbers till there is one LED
light remaining. The last battery level LED indicator light will begin to blink when the battery drops below 10%. If the
battery reaches 0% while recording, the camera saves the file and powers off.
Note: (Tactacam 2.0) the Green LED will blink fast when the battery reaches the final 5% of life.
MAXIMIZING BATTERY LIFE
Extreme cold temperatures can decrease battery life. To maximize battery life in cold conditions, keep camera in a
warm place prior to use. Protect the Rec/Power Button to prevent the camera from accidentally turning on.
CHARGING TIME USB CORD WALL PLUG
The battery charges to 80% in approximately two hours and 100% in approximately three hours when using
Tactacam's USB-compatible charger, Wall Charger for 4.0 and 3.0, or other USB charging adapter. Other chargers
might charge at a slower rate.
WARNING: Using a wall charger other than a Tactacam's Wall Charger can damage the Tactacam's camera battery and
could result in fire or leakage. Only use chargers marked: Output 5V 1A. If you do not know the voltage and current of your
charger, use the included USB cable to charge the camera from your computer.
(844) 482-2822
12
Hide quick links:
Advertisement
Table of Contents
