Philips HD6180/02 User Manual page 14

EnglisH
1
Problem
The PreClean
function cannot
be activated.
Oil or fat spills
over the edge of
the fryer during
frying.
The oil or fat
foams strongly
during frying.
The fryer does
not work.
The fryer makes
plopping sounds
that are louder
than usual (it is
normal for the
fryer to make
soft plopping
sounds).
Possible cause
The water reservoir has
not been inserted
properly.
More than 30 seconds
elapsed between the
moment you switched on
the appliance and the
moment you pressed the
PreClean button. In this
case, the PreClean
function is not activated.
There is too much oil or
fat in the fryer.
The food contains too
much moisture.
There is too much food in
the frying basket.
The food contains too
much moisture.
The type of oil or fat used
is unsuitable for deep
frying food.
The inner bowl has not
been placed properly in
the fryer.
The thermal safety cut-out
has switched off the
appliance.
The food contains too
much moisture.
Solution
Check whether the water reservoir has been
inserted properly (you hear a click).
Set the on/off switch to 'I' to switch on the
appliance. Then press the PreClean button
within 30 seconds.
Make sure the oil or fat in the fryer does not
exceed the maximum level.
Dry the food thoroughly before you fry it. Then
fry the food according to the instructions in this
user manual.
Do not fry more food at one time than the
quantities mentioned in the food table at the
end of this booklet.
Dry the food thoroughly before you fry it.
Never mix different types of oil or fat and use
oil or liquid fat that contains an antifoam agent.
Move the inner bowl slightly to and fro in the
appliance to ensure that it is in the correct
position.
Let the oil or fat cool down. Carefully press the
reset button at the front of the fryer (see
chapter 'Safety').
If the fryer still does not work, go to your Philips
dealer or a service centre authorised by Philips.
Dry the food thoroughly before you fry it.