pro user DRC4310Solar Operating Manual page 11

Monitor Installation
When choosing a location to mount the monitor, make sure the monitor is in an
area that will not obstruct your vision while driving.
1. Before mounting the monitor, clean the mounting surface well.
2. Position the suction mount to the smooth surface which suits your
requirement.
3. Press the suction cap against the smooth surface and press the lock down to attach and fix the
mount to the surface.
4. Snap in the monitor to the suction mount.
5. Adjust the mounting arms to suit your view angle to the monitor and tighten the screws on the
mount to fix the position.
6. Route the power cable to the vehicle's cigarette lighter socket 12V/24V power outlet. The cable
must not interfere with the safe operation of the vehicle.
7. Insert the small 12V/24V DC plug of the power cable into the right side of the monitor.
8. Plug the 12V/24V cigarette lighter plug into the vehicle's cigarette lighter socket.
To maximize the effectiveness of the suction mount, it is recommended that the application be
performed under the following conditions:
•
Surface temperature should be between 21 and 38 degrees Celsius.
•
Application below 10 degrees should be avoided.
•
Application should not occur in direct sunlight.
Mounting should be protected from exposure to direct sunlight for a period of 24 hours.
11