Trouble Shooting - Nilfisk-Advance SO 4500 User Manual

Technical
Boiler
Wattage:
1950W
Type:
Stainless Steel
Capacity:
1.8 Litres
Continuous Fill
Steam Pressure:
4.5 Bar
Steam at source:
135°C >
Electrical
Voltage:
230V ~ single phase
Low Voltage Controls:
5V
Cord length:
10m
Capacities
Boiler:
1.8 Litres
Cold Water Tank:
5 Litres (easy fill)
Weight:
12kg
English
Trouble
Shooting
No Power
Not Check connection
connected
to wall socket and
or faulty socket switch. Try
power
in another wall
cable socket
On / Off Press On / Off
switch not switch which will
on illuminate when on
Fuse blown
Replace fuse with
approved 13A fuse
Unknown Call for service
No steam
Steam Control Turn the
turned down control to half
fully clockwise way
Steamer not Wait for the
ready
"Ready to
steam" light to
illuminate
Clean water Pour water into
tank is low the clean water
(beeping tank until the
sound& "refill" beeper stops.
light is lit) The steam
handle will
work again.
Unknown Call for service
No steam, Just water
Steamer
Wait for the "Ready
not ready to steam " light to
illuminate
Boiler at Hold the steam
pressure switch on for
and not approximately one
heating(te minute, ever if just
mperature water is coming out.
less than
This will result in the
110ºC) heater coming back
on
Unknown Call for service
Steam Leaking from
front socket
"O" Change and re grease
Rings "O" Rings. To avoid
split
this happening ensure
"o" rings are grease
before every use.
"O"
Change and re grease
rings "O" Rings. To avoid
worn this happening ensure
"o" rings are grease
before every use.
Page 7