Begin Self-Installation - Sprint S1000R User Manual

Begin Self-Installation

When you power on your S1000R for the first time, it will go through an automated setup sequence.
1. During boot-up the device LEDs will be solid green for a few seconds during initial hardware tests.
This takes approximately 8 to 10 seconds.
2. The WAN LED will turn solid green; all other LEDs will be OFF. This takes approximately 8 to 10
seconds.
3. The WAN LED will stay solid green; all other LEDs will blink red.
NOTE: Steps 1 through 3 are expected behavior.
4. The NET LED will turn solid green. This will take approximately 15 minutes.
NOTE: If the WAN or NET LEDs are solid red after 15 minutes, talk to your IT administrator to diagnose
problems with your internet connection.
5. This is a good time to take a break.
The device will go continue the self-installation process. During this time the device may download
software images and perform automatic synchronization. The device may also restart a couple of
times.
Return after 60 minutes and check the LEDs. All LEDs should be solid green.
LED Label
WAN
NET
GPS
LTE
WIFI
NOTE: If all LEDs are not solid green call Customer Care as described in
Getting Started
Description when solid Green
Successful connection to the local LAN
Successful connection to Sprint's Core Network
GPS lock achieved
4G Data Services are available
WiFi Services are available
Getting help.
8