Adjusting Your Monitor Image; Using The Direct Access Controls; Using The On-Screen Display (Osd) Controls - Lenovo G34w-10 User Manual

Adjusting your monitor image

This section describes the user control features used to adjust your monitor image.

Using the direct access controls

The direct access controls can be used when the On Screen Display (OSD) is not displayed.
Table 2-1. Direct access controls

Using the On-Screen Display (OSD) controls

The settings adjustable with the user controls are viewed through the On-Screen Display (OSD),
as shown below.
To use the controls:
1. Press
2.
3. Press
4. Press and hold
5. Enables DDC/CI by default. Use OSD Exit Key, press and hold the
Icon Control
Input change
DDC-CI
Main menu
NO function
Brightness
Low Blue Light
to open the main OSD menu.
Use or to move among the icons. Select an icon and press
function. If there is a sub-menu, you can move between options using
press to select that function. Use
save.
to move backwards through the sub-menus and exit from the OSD.
for 10 seconds to lock the OSD. This will prevent accidental
adjustments to the OSD. Press and hold
and allow adjustments to the OSD.
seconds to disable/enable DDC/CI function. The words " DDC/CI
Disable/DDC/CI/Enable" shows on the screen.
Description
Switches the video input source.
Press and hold for 10 seconds to
enable or disable the DDC-CI function
Open OSD main menu
Press and hold for 10 seconds will lock
menu/unlock menu
Direct access to Brightness adjustment.
Press and hold for 3 seconds will enable or
disable the Low Blue Light
or
to make adjustments. Press
for 10 seconds to unlock the OSD
to access that
or , then
to
buttons for 10
Chapter 2. 2-4