Kannad 406 AF-COMPACT Quick Installation Manual page 7

Determine RC200 location on or below the instrument panel (be sure the location meets the
requirements established in RTCA-DO-183) in an area that is not directly exposed to sun rays.
1. On the instrument panel
- Mark a cutout on the instrument panel according to the Drilling mask (Refer to § 4. RC200 Drilling
Mask, page 504 of installation manuel).
- Make the cutout.
- Mark the 4 holes needed for the RC200 using the drilling mask or the RC200 as a guide.
- Drill the 4 marked holes, diameter depending on rivets bush used.
- Install the RC200 by fitting it into the cutout.
- Secure the RC200 (4 rivets bush recommended).
2. Below the instrument panel
- According to the "area to be drilled" (1) of the mounting tray (3), determine the location of the screws
or rivets (2) used to secure the mounting tray (3) to the instrument panel (4).
- Drill 2 holes on the mounting tray and on the instrument panel, diameter depending on screws or
rivets used.
- Secure the mounting tray (3) to the instrument panel (4).
- Secure the RC200 (5) to the mounting tray (3) with the 2 screws (6) supplied (torque 0.8 Nm).
INSTRUMENT PANEL
3
PAGE 7
6. INSTALL RCP
2
1
QUICK INSTALLATION GUIDE
4
KANNAD 406 AF-COMPACT
6
5