System Map: Left View - ONE K73-8M Concise User Manual

System Map: Left View

1
Thunderbolt Port for Display
The display configuration for the Thunderbolt port and Mini DisplayPorts can
be set up in the BIOS. Restart your computer and press F2 to enter the BIOS
(Advanced menu > Advanced Chipset Control > DDI Control).
The table below outlines which ports will be enabled/disabled when the Thun-
derbolt port is set for display only.
Setting
Thunderbolt 3 Port
Mini DisplayPort #1
Mini DisplayPort #2
1. Vent
2. DC-In Jack
3. HDMI-Out Port
4. Mini DisplayPort 1
5. Mini DisplayPort 2
6. USB 3.1 Gen 2 Type-C Port
Or
(Factory Option) Thunderbolt 3 Port (Type-C)
7. USB 3.0 (USB 3.1 Gen 1) Type-A Ports
Left
3
2
DDI to mDP
(Default Setting)
6 Disabled
4
Enabled
5 Enabled
Figure 7 - Left View
6 7 7
4 5
When plugging a device into a Thun-
derbolt port alllow 30 seconds for the
system to scan and recognize the con-
nected device.
DDI to TBT
In order to prevent system problems
make sure you do not simply pull the
Enabled
cable out from the Thunderbolt port.
The hardware must be ejected safely:
Disabled
1. Go to the notification area of the
Enabled
2. Click on Eject "Thunderbolt Device
3. When you see the "Safe to Remove

Thunderbolt Devices
Ejecting Thunderbolt Devices
taskbar and click on the Safely Re-
move Hardware and Eject Media
icon.
Name".
Hardware" message you can re-
move the cable after about 20 sec-
onds, to make sure that it is safe to
eject the device.
13