Table of Contents
Advertisement
Precautions for Handling of Internal Devices
Do not disassemble, repair, or modify the product yourself
Do not disassemble, repair, or modify this product. Doing so may cause an electrical
shock or a fire. Do not put the product close to fire, or immerse it in water. Doing so may
cause an explosion. If the product does not function normally, contact your service
representative.
Unplug all power cords
Turn the power off and unplug the power before removing the computer's cover. Failure to
do so could endanger you and may damage the adapter or computer
Avoid installation in extreme temperature conditions.
Immediately after the server is powered off, its internal components such as heat sink are very hot.
Leave the server until its internal components fully cool down before installing/removing any
component.
Ground yourself to dissipate any static charge before handling the adapter.
To prevent any damage on components due to static electricity, make sure to discharge
static electricity from yourself before you touch this adapter.
Don't touch uncoated metal parts on adapter.
Never touch this adapter's LAN port, terminals of components or uncoated metal parts
on adapter. Otherwise, taint, erosion or others may cause loose connection. Do not
touch this product with wet or dirty hands.
Excessive force could break the connector.
On installing this adapter, do not insert it by force. Otherwise, this adapter and the
server may be damaged.
Don't touch the tip of bracket to other parts of server
When you insert this adapter into expansion slot, be careful not to touch the tip of
bracket to other parts of server (such as other components or board). Otherwise, they
may be damaged.
Firmly connect the network cable
When connecting the cable, insert the cable connector until you hear a click sound.
E-6
Advertisement
Table of Contents
