Advertisement
7. TESTING THE AUTOMATED SYSTEM
Check operating efficiency of the automated system and all
accessories connected to it.
Hand the "User's Guide" page to the Client, explain correct
operation and use of the operator and indicate the
potentially dangerous areas of the automated system.
8. MANUAL OPERATION
If the gate has to be operated manually, turn off power and
proceed as follows:
1) Slide the protective tab, Fig.9 / 1.
2) Fit the key and turn it through 90°, Fig.9 / 2.
3) Lift up the manoeuvre lever, Fig.9 / 3.
4) To release the operator, turn the manoeuvre lever
through 180°, as shown by the arrow on the release
system Fig.9 / 4.
1
3
Open or close the leaves manually.
Attention: to keep the operator in manual operation mode,
the operator must be released and without power.
9. RESTORING NORMAL OPERATION
To restore normal operation mode of the automated system,
turn the metal lever clockwise, close the cover and switch
on power to the system.
Carry out some manoeuvres in order to check if all functions
of the automated system have been correctly restored.
10. MECHANICAL STOP
The SKILL operator is equipped with an opening mechanical
stop, Fig.10, which can be adjusted according to need.
Fig. 10
Procedure for adjusting the stop position:
1) Release the operator as described in point 8.
2) Manually take the leaf into its opening position.
3) Loosen the fixing screw, Fig.11 ref. A. There is no need to
fully remove the screw.
2
Fig. 11
4) Shift the stop to the lower support, as shown in fig. 12.
Attention: the mechanical stop operates coupled to a
sector gear, Fig. 11 ref. B, if anything occurs to impede
movement, make sure the coupling is unrestricted. Do
4
not force.
5) Re-tighten the fixing screw.
Fig. 9
Fig. 12
13.ADJUSTING THE LIMIT-SWITCHES
N.B.: The LS versions imply the use of equipment with an input
for the limit-switches.
The limit-switches are tripped only during the first and last 25
mm of travel. As result, the full travel distance must be used.
1) Remove the mechanical stop and the lower housing, in
the order described, as indicated in Fig. 13.
Fig. 13
9
B
A
ENGLISH
Advertisement
