Installing The Coffee Machine; Preparing The Coffee Machine For Use - Gaggia SYILX014MENGRC Operating Instructions Manual

4 INSTALLING THE COFFEE
MACHINE
For your own safety and the safety of others,
follow the "Safety Rules" (see chapter 3).
4.1 Packaging
The original packaging was designed and made
to protect the appliance during shipment.
We recommend you keep it for future needs.
4.2 Preliminaries
• Remove the coffee machine from the
packaging and position it in a suitable location
that meets the requirements specified and
described in the safety rules (chap.3).
• Remove the drip tray (12) from the packaging
and fit it into the machine.
• Make sure that the drip tray and plate
(Fig.01-12), the dregs drawer (10) and brew
unit (17) are fitted correctly in place and
the side door (15) is closed.
• From the dregs drawer, take the cleaning
brush (20), brew unit key (19) and measuring
scoop (21) provided with the machine and
keep them within reach.
If the display signals a fault when
you switch on the machine, it means
that one of the above-described com-
ponents has not been properly positioned
(Section15).
4.3 Preparing the coffee machine for
use
• Open the water tank cover and remove the
tank (Fig.03). Rinse and fill with fresh drinking
water; we recommend that you do not exceed
the "MAX" level mark. Replace the water tank
in its housing and reposition the cover on top
(Fig.04).
Always fill the tank (9) with fresh still
water. Hot water and other liquids
can damage the tank and/or the appliance.
Do not operate the appliance without
water: make sure that there is enough
water inside the tank.
• Lift the cover (2) and fill the container with
coffee beans (1).
Use coffee beans only. Ground and
instant coffee, as well as other items,
will cause damage to the appliance.
• Set the cover back in place on the coffee
container (1).
• Make sure that the ON/OFF switch (7) is
positioned on (O).
Insert the plug (11) into a suitable wall outlet.
• The machine ON/OFF switch is set on "O"
(OFF); to turn the machine on just press the
button; the machine will begin to heat up and
the display will show:
When the machine reaches the right tempera-
ture, it will carry out a rinse cycle.
• To load the water circuit, direct the steam tube
(Fig.01-14) over the drip tray and place a cup
or other suitable receptacle beneath the steam
nozzle.
• Turn the knob (Fig.09) anticlockwise and wait
until water is discharged from the steam nozzle
in a steady stream; to stop the flow of water,
turn the knob clockwise.
During this operation the display will show:
HOT WATER
WARMING UP ...
Note: After a long period of disuse,
if the water tank has been completely
emptied, you must reload the circuit before
starting up the machine. The circuit must
also be loaded every time the display shows
the following message:
• 29 •
ENGLISH
RINSING
WARMING UP ...
VENTILATE