Download Print this page

Ariston CLAS 24 FF User Manual page 8

Advertisement

manuale d'uso
I
MPORTANTE
Se il blocco si ripete con frequenza, si consiglia l'intervento del Centro
di Assistenza Tecnica autorizzato. Per motivi di sicurezza, la caldaia
consentirà comunque un numero massimo di 5 riarmi in 15 minuti
(pressioni del tasto
).
Nel caso in cui il blocco sia sporadico o isolato non costituisce un
problema.
Arresto Temporaneo per anomalia evacuazione fumi
(24 CF) 601
601
Tale controllo blocca la caldaia in caso di anomalia di evacuazione
fumi. Il blocco dell'apparecchio è temporaneo ed è segnalato con
codice di errore 601
601. Dopo 12 minuti la caldaia inizia la procedura di
accensione; se le condizioni sono ritornate alla normalità prosegue
nel funzionamento in caso contrario la caldaia si blocca ed il ciclo si
ripete.
ATTENZIONE!
In caso di malfunzionamento o di interventi ripetuti spegnere la
caldaia, togliere l'alimentazione elettrica portando l'interruttore
esterno in posizione OFF, chiudere il rubinetto del gas e
contattare il Servizio Assistenza o un tecnico qualifi cato per
rimediare al difetto di evacuazione dei fumi verifi cando la causa
del malfunzionamento.
Sicurezza antigelo
La caldaia è dotata di una protezione antigelo che provvede
al controllo della temperatura di mandata della caldaia: se tale
temperatura scende sotto i 8°C si attiva la pompa (circolazione
nell'impianto di riscaldamento) per 2 minuti.
Dopo i due minuti di circolazione la scheda elettronica verifi ca
quanto segue:
a- se la temperatura di mandata è > di 8°C la pompa si ferma;
b- se la temperatura di mandata è > di 4°C e < di 8°C la pompa si
attiva per altri 2 minuti;
c- se la temperatura di mandata è < di 4°C si accende il bruciatore
(in riscaldamento alla minima potenza) fi no al raggiungimento
dei 33°C. Raggiunta la temperatura il bruciatore si spegne ed il
circolatore continua a funzionare per altri due minuti.
La protezione antigelo è attiva solo con la caldaia perfettamente
funzionante:
- la pressione dell'installazione è suffi ciente;
- la caldaia è alimentata elettricamente, il simbolo
- il gas viene erogato.
8
user's manual
Important
If this shutdown occurs frequently, contact an authorised service centre
for assistance. For safety reasons, the boiler will allow a maximum of 5
reset operations to take place in 15 minutes (individual presses of the
button).
If the shutdown is occasional or an isolated event, this is not
Necessarily a problem.
Temporary Shut-Off due to defective fl ue gas discharge (CF) 601
This device causes the boiler to shut down in the event of an anomaly
in the fl ue gas discharge. The appliance shutdown is temporary and
is signalled by error code 601
After 12 minutes, the boiler begins the ignition procedure; if normal
conditions have been restored, the boiler operates as normal. If not,
the boiler shuts down and the cycle is repeated.
WARNING!
In the event of a malfunction or if repeated intervention is re-
quired, switch the boiler off , shut off the electricity supply by
turning the external switch to the OFF position and shut off the
gas valve. Contact the Technical Assistance Service or a qualifi ed
technician in order to repair the fl ue gas discharge fault once the
cause of the malfunction is detected.
Anti-frost Device.
The anti-frost function acts on the central heating fl ow temperature probe,
independently from other settings, when the electrical supply is turned on.
If the primary circuit temperature falls below 8°C the pump will run for 2 mi-
nutes.
After the two minutes of circulation (fi xed) the boiler will check the fol-
lowing:
a - if the central heating fl ow temperature is > 8°C, the pump stops;
b - if the central heating fl ow temperature is between 4 and 8°C, the pump
will run for another two minutes;
c - if the central heating fl ow temperature is < 4°C, the burner will fi re
(heating position) at minimum power until the temperature reaches
33°C, the burner will go off and the pump will continue to run for two
minutes.
The anti-frost device activates only when (with the boiler operating cor-
rectly):
- the system pressure is correct;
- the boiler is electrically powered, the symbol
è illuminato ;
- there is a supply of gas.
601..
is illuminated;

Advertisement

loading

This manual is also suitable for:

Clas 28 ffClas 24 cf