Installing Motorcycle Mount Enhanced Control Head - Motorola Malux MTM5x00 Series Installation Manual

68015000181-LB
Chapter 4: Radio Installation
4.5.1

Installing Motorcycle Mount Enhanced Control Head

Planning is the key to fast, easy radio installation. Before a hole is drilled or a wire is run, inspect the
vehicle and determine how and where you intend to mount the antenna, radio, and accessories. Plan
wire and cable runs to provide maximum protection from pinching, crushing, and overheating.
NOTICE: The installation planning should only be undertaken by persons who are competent
and able to ensure that the complete installation fulfils its regulatory requirements, such as
EMC (ElectroMagnetic Compatibility). Be sure that the distance from the antenna location on
the transceiver enclosure will be at least 30 cm or 1 foot to the motorcycle operator to assure
compliance with RF Energy Safety standards. To assure that human exposure to radio
frequency electromagnetic exposure is within the guidelines referenced in this document,
transmit only when bystanders are at least the minimum distance (90 cm or 3 feet) from the
motorcycle.
When and where to use: The following list of considerations should, as a minimum, be checked
during installation planning:
Procedure:
1 The recommended place for the transceiver is to place it in the box at the back of the
motorcycle.
2 Mount the Motorcycle Mount Enhanced Control Head horizontally at a position which enables
the driver to view the controls and operate them easily.
3 Be sure that the Motorcycle Mount Enhanced Control Head is close enough to the vehicle
operator to permit easy access to operating controls.
4 It is recommended to mount the Motorcycle Mount Enhanced Control Head directly on the
chassis or handle part.
5 Ensure that the units mounted in the motorcycle box are protected from dirt and moisture.
6 Verify that there is sufficient space around the units to allow air flow and removal.
7 Verify that the cable from a handlebars mounted Motorcycle Mount Enhanced Control Head and
to the radio unit is long enough to allow for the handles to be turned.
8 Verify that the antenna cable is routed in the shortest way to minimize power loss over the cable.
9 Check that the mounting surfaces are able to support the weight of the units.
NOTICE: If an additional GPS antenna or a combined TETRA/GPS antenna is used, the
antenna housing carries the GPS/GNSS receiver. Take care not to cover the antenna
housing with metal or other radio wave absorbing material.
74 Send Feedback