Adding Ipsi Information - Avaya S8700 Series Installing And Configuring

Translating the IPSIs
2. Verify that the Primary and Secondary Subnet Addresses are correct.
The subnet addresses must match the most significant 3 octets (the first three groups of
digits in the subnet address) of the Server IP address.
An asterisk (*) to the right of the Subnet Address field means that although a subnet
address is displayed, it is not the correct one; Avaya Communication Manager does not
have the subnet information. After verifying the displayed information, submit this form with
or without changes to update the software with the correct subnet information.
!
CAUTION:
If the information displayed in the Primary Control Subnet Address and/or
CAUTION:
Secondary Control Subnet Address fields is not correct, it must be changed on
the media servers. Use the Maintenance Web Interface; under Server
Configuration and Upgrades, click Configure Server to change the media server
configuration. Then return here to perform this step.
3. Set the Switch Identifier: field to the switch ID letter (A through J; A is the default setting).
4. Set the IPSI Control of Port Networks: field to enabled.
5. Press Enter to effect the change.

Adding IPSI information

Note:
The information you provide differs, depending on whether the IPSIs get static
Note:
addresses or they are assigned automatically through DHCP.
These steps add the IPSI information to the translations.
1. Type add ipserver-interface PNnumber and press Enter to add the IPSI circuit pack
information.
54 Installing and Configuring the Avaya S8700 Series Media Server