Fanimation FPD6235 Series Manual page 13

How to Operate Your Ceiling Fan (continued)
4. If you have multiple fans and want to program all fans
to one handheld control, connect all fans to their power
supply and follow Step 6 of the remote control set up
process. Each fan needs to be no more than 30 feet from
the handheld control that you would like to program.
5. If you have multiple fans and want to program each to
separate handheld controls, connect one fan at a time to
their power supply and follow Step 6 of the remote control
set up process. Before you connect the second fan to
their power supply, you must first power off the first fan
that was set up. Repeat these steps for each fan that you
would like to program to a separate handheld remote.
6. Remote Control Setting and Speed (RPM)
Setting Process : (Figure 4)
1) After installing and wiring the unit, restore power to
your fan by ensuring that the breaker and wall switch that
controls the power supply is moved to the on position,
press and hold the "SET" button inside of the battery
compartment of the handheld remote control for 1-3
seconds.
2) You must press the "SET" button within 30 seconds of
restoring power to the fan.
3) When restoring power to your fan at the wall switch and
breaker, DO NOT press any button(s) on the handheld
remote control before pressing the "SET" button, otherwise
the fan will fail the learn procedure.
4) If you press any button(s) on the handheld remote
control before pressing the "SET" button, please turn the
wall switch that controls the power to the fan to the o
position then on again, and start the process beginning
with Step 1 above.
5) When you press the "SET" button the fan will make
two musical sound, and it has finished the control set up
process.
6) The fan is now ready for normal use.
Dip Switch
13
SET
Figure 4