Table 1-13 Character Set Selection - Epson DFX-8000 Service Manual

On
On
I
On
Note: In IBM mode, you select the default character table using DIP switches 1-6, 1-7, and 1-8. When
character table 1 is selected, hex codes 80H-9FH are control codes (function the same way as when
you use the ESC 7 command). When character table 2 is selected, hex codes 80H-9FH are printable
characters (function the same way as when you use the ESC 6 command).
Switch 2-5
On
On
Switch 2-7
On
On
DFX-8000
Table 1-13. Character Set Selection
Table l-14. Interface Settings
interface Setting
Switch 2-6
Off Parallel interface
Serial interface, odd parity
On
Off Serial interface, even parity
On Serial interface, no parity
Table 1-15. Baad Rate
Switch 2-8 Baud Rate (bps)
19206
On 9600
off 1200
On
Character table 2
300
General Description
1-37