Installing The Rapidrails Slide Assemblies - Dell PowerEdge 1-U Keyboard Tray Installation Manual

2
Push the slide assembly forward until the mounting hook enters its respective square hole on
the vertical rail, and then push down on the mounting-bracket flange until the mounting
hooks seat in the square holes and the push button pops out and clicks. See Figure 1-4.
Figure 1-4. Installing the RapidRails Slide Assemblies
3
At the back of the cabinet, pull back on the mounting-bracket flange until the mounting
hooks are located in their respective square holes, and then push down on the mounting-
bracket flange until the mounting hooks seat in the square holes and the push button pops
out and clicks.
4
Repeat step 1 through step 3 for the slide assembly on the other side of the rack.
1-10
Installation Guide
front of rack
NOTE:
Ensure that the rails are mounted at the same position on the vertical rails on each side
of the rack.
10-32 x 0.5-inch flange-head Phillips screws and centering
washers (2 sets per slide assembly); optional
slide assemblies (2)
push button
mounting hook
hole for optional screw
mounting-bracket flange
support tab