Table of Contents
Advertisement
1
Installation
The NVR device is referred to as device in this manual.
You need a cross screwdriver or straight screwdriver to complete the
installation.
Installing the Hard Disk
CAUTION!
Disconnect power from the device before installation. Wear antistatic
gloves during the installation.
The following figures are for your reference only. The actual
appearance may vary depending on your device model.
Follow the steps:
1.
Loosen the screws and remove the chassis cover.
2.
Tighten the screws on the hard disk halfway. You are
recommended to tighten two screws on the diagonal at first.
1
Advertisement
Table of Contents
