Adding An Ip Camera By Plug-And-Play - UNV NVR202 Series Quick Manual

3. Input the IP address and then select the protocol that the device
supports. Input the service port number, username and password,
and then click OK.
4. On the Channel tab, check the connection status.

Adding an IP Camera by Plug-and-Play

NOTE!
Adding an IP camera by Plug-and-Play is only applicable to the

device with PoE ports or switching ports.
The channels connected through PoE ports or switching ports do not

support Delete operation.
1. Connect the IP camera to a PoE port or a switching port on the
rear panel with a network cable.
2. Click Menu > Channel > Channel. The device uses plug-and-play
as the default way to add IP cameras. After adding an IP camera
successfully, the device changes the IP address of the camera into
the IP address of the internal NIC.
15