DIGITAL YACHT AQUA COMPACT PRO MARINE PC Installation And Instruction Manual

Table of Contents

Download this manual

AQUA COMPACT

PRO MARINE PC

Table of Contents

Need help?

Do you have a question about the AQUA COMPACT PRO MARINE PC and is the answer not in the manual?

Page 1 AQUA COMPACT PRO MARINE PC...
Page 2: Before You Start
Congratulations on the purchase of your Aqua Compact Pro PC. It is recommended that your new computer is installed by a professional installer. The Aqua Compact Pro PC is 12v ONLY and must not be connected directly to a 24v DC supply. Please consult your dealer or with Digital Yacht on suitable 24v to 12v DC-DC adaptors. ...
Page 3  The USB Interface Standard specifies that USB cables should be no longer than 5m without using a special powered USB extender cable – ensure that the total USB cable length from the Aqua Compact Pro PC to any USB device is < 5m. Installation Step 2 ...
Page 4  Please note that the Aqua Compact Pro enclosure is internally connected to the negative supply. Extreme care should be taken when routing positive supply cables close to the Aqua Compact Pro and you should not secure the Aqua Compact Pro on to a metallic or conductive surface as this may affect the boat’s grounding. Always ensure that the Aqua Compact Pro enclosure and any USB and HDMI cables are not connected to the boat’s ground.
Page 5 To connect NMEA devices to the Aqua Compact Pro PC you will need either;  A Digital Yacht USB to NMEA0183 adaptor (P/No.ZDIGUSBNMEA)  One of the Digital Yacht Wireless NMEA products; WLN10, NavLink, iNavHub, iAIS or PilotLink  A suitable NMEA2000 gateway such as our iKommunicate ...