Key To Led Codes; Remote Control Of The System 5C C C C C R R R R R Plus - Extron electronics System 5cr Plus User Manual

im Vertrieb von

Key to LED Codes

Setup
Status
mode is
active
TX
Off
CONFIG
On
RETRY
Off
Configure
What
a
to do
System 5
next feature.

Remote Control of the System 5c c c c c r r r r r Plus

www.camboard.de
CAMBOARD Electronics
To interpret the System 5's response to the IR learning steps, see the LED response
codes below.
Ready to Command
learn IR has been
commands learned
Off Blinks once
Blinking On
Off Blinks once
Aim projector's
Continue
remote at IR with setup
learning port. or exit to
Press a button normal
for the mode.
function on
the remote.
The System 5 can be controlled by using its front panel controls, the included
IR 401 infrared remote control, optional SCP remote control panels, or an
RS-232 control device or computer.
The IR 401 and SCP control panels replicate the System 5's front panel controls for
normal mode operations. The RS-232 control device also can send front panel
normal mode commands. A computer using Extron's Windows-based control
program can perform both normal mode and setup mode operations, and it offers
some functions that are not available with the other control methods. See chapter 4,
Serial Communication, for details.
The IR 401 uses and
place of the volume knob. It also has
an audio mute button.
Setup mode operations can not be
performed from the IR 401.
The SCP 100P, SCP/AAP A, and SCP 250 can be mounted in a wall or furniture.
Each includes an IR remote window (corresponding to the IR receiver port on the
SHOW ME AUDIO
MAX/
VOLUME
MIN
DISPLAY
POWER MUTE
MODE
SCP/ AAP A
Tel. 07131 911201
Fax 07131 911203
No IR Ready to learn
Try again subcarrier the power-off
was received
Off Off
On On
Blinks once Blinking
Press the Press the Double-click the
same button same System 5
again on the Display button Display Power
projector's again, button, then press
IR remote. and press the the power button
IR remote's on the projector's
button again.
buttons in
Control Functions Audio
Display Display
Mute
Power Mute
Mode Volume
Room
Input Selection
1 2 3 4
5
IR 401
System 5cr Plus Remote
System 5) or IR signal pickup device for receiving
commands from the IR 401 remote control and sending
them to the System 5. Infrared signals from other
devices are not passed on to the IR Emitter or the IR
Broadcaster. Up to two SCPs can be connected to the
System 5.
ce-info@camboard.de
System 5c c c c c r r r r r Plus • Setup and Operation
Timeout exit to
normal mode
command
will occur
Off Blinks for 5 seconds
Blinking Blinks for 5 seconds
Blinking Blinks for 5 seconds
Press any
button to stay in
System 5's
setup mode.
remote.
Control Functions Audio
Display Display
Mute
Power Mute
Volume
Mode
Room
Input Selection
1 2 3 4
5
3-7