Integrant atHand Instructions For Use/Assembly Instructions page 8

Assembling the base to the spine
1. With the spine/tray assembly lying flat, hold the tray table arm
in place and remove the strap. Allow the tray table to slide up
the spine slowly.
2. Align the bottom of the spine with the uncovered oval shaped
opening in the base.
3. From the hardware kit, place one washer onto each of the four
screws and insert into each of the 4 holes located on the under
side of the base.
4. Using the hex wrench provided in the hardware kit, tighten each
screw, following an X pattern.
5. Keep the table lying flat.
Assembling the shelves
1. Remove the lower shelf from box 2 and upper shelf from box 3.
8