Serial Port Communication Parameters (Config.txt) - inout Dinplayer D01-MKII User Manual

8.2 Serial port communication parameters (config.txt)

The parameters of the RS485 serial port (length of the packs, parity, speed, etc.) are set
via the configuration file config.txt.
Example file config.txt:
LLOU=10
LTRE=14 Audio adjustment parameters
LBAS=10
CMAD=0
CMCK=1
CMCL=0
CMBR=3
CMPR=0 RS485 serial port communication parameters
CMSB=1
CMDB=8
CMDR=0
CMNR=0
These parameters must coincide with those of the outside device with which DINplayer is to
communicate.
IMPORTANT:
To make the modification of these parameters effective, it is necessary to restart DINplayer
after having introduced the flash memory with the file config.txt.
If DINplayer is not used with Playlist or as music player, set MPLL=0 in the config.txt.
IMPORTANT:
Conditions in which a transmission sequence is initialised.
The DINplayer transmission sequence is initialised under the following conditions:
When DINplayer is turned on.
When the data communication has been normally completed.
When the timeout time for receiving a pack has expired.
DINplayer User Manual v.2.3
notes for the Master system
Page 30