inout Dinplayer D01-MKII User Manual page 10

DINplayer User Manual v.2.3
2. DINplayer with 6 logical inputs and amplified 20W mono output.
The 20W mono amplifier can directly drive an external loudspeaker with the impedance
of 4 min. To set the amplified mode, lift the clamps cover and move the jumpers P3
Ω
and P4 as in figure.
Attention! Use a loudspeaker with equal or greater power than the one driven by the
internal amplifier.
Do not to place the audio connection cables close to the electric power cables to avoid
possible troubles.
To set the logical inputs mode, lift the clamps cover with a screwdriver and move the
jumpers P3 and P4 like in figure.
IMPORTANT:
Check if the MOMD parameter is correctly setted (par. 4.7)
MOMD=0, power amplifier ACTIVE.
6 logical inputs and amplified
MONO output
Page 9