Dinplayer Configurations - inout Dinplayer D01-MKII User Manual

3.5 DINplayer Configurations

DINplayer in addition to the 6 logic inputs for the audio files activation has a mono 20W
amplifier to directly drive an external loudspeaker and it can be connected through the
serial port to an RS485 bus, to be controlled by a master system or by a computer.
To configure the device to meet your needs, gently use a screwdriver to lift the clamps
cover and to move the P1, P2, P3, P4 jumpers as displayed below.
1. DINplayer with 6 logical inputs and preamplified STEREO output.
In the "factory default configuration" the logical inputs mode is active and the power
amplifier is NOT active.
IMPORTANT:
Check if the MOMD parameter is correctly setted (par. 4.7)
DEFAULT: MOMD=2, power amplifier NOT ACTIVE.
6 logical inputs and preamplified
STEREO output (DEFAULT)
DINplayer User Manual v.2.3
Page 8