Accessories - Toro V-21S 20489 Operator's Manual

petroleum distillate based conditioner/stabilizer.
Toro does not recommend stabilizers with an
alcohol base, such as ethanol, methanol or
isopropyl. Use fuel additive in recommended
quantities as specified on container.
Under normal conditions, fuel additives remain
effective in fuel for 6-8 months.
2. Drain oil: refer to Change Engine Oil, page 12.
After oil is drained, do not fill crankcase with oil
until the following steps (3–10) are completed.
3. Remove spark plug and pour 30 ml
(2 tablespoons) of SAE 30 oil into hole in
cylinder. Pull starter rope slowly to coat inside of
cylinder. Install spark plug and tighten to
15 ft–lb (20 N m). DO NOT INSTALL WIRE
ON SPARK PLUG.
4. Clean mower housing; refer to Cleaning,
page 15.
5. Check condition of blade; refer to Blade,
page 14.
6. Tighten all nuts, bolts, and screws.
7. Clean dirt, chaff, grass clippings, and grime from
external parts of the engine, shrouding, and top
of mower housing.
8. Clean air cleaner; refer to Air Filter, page 12.
EN–16
9. Lubricate the wheels; refer to Lubrication,
page 15.
10. Touch up all rusted or chipped paint surfaces.
Toro Re–Kote paint is available from an
Authorized TORO Service Dealer.
11. Fill crankcase with oil; refer to Oil, page 6.
12. Store mower in a clean, dry place. Cover mower
to keep it clean and protected.

Accessories

For special conditions, the following accessories may
be purchased at your local Authorized Toro Service
Dealer.
1. Dethatcher Kit, Model No. 59131 – Installs in
minutes. Front mounted for easy
maneuverability (Fig. 27). Spring tines loosen
thatch for clean vacuuming into grass bag and
convenient disposal.
2. Leaf Shredder Kit, Model No. 59180 – Installs
on underside of mower in minutes without
requiring removal of blade. Shreds leaves into
small pieces for clean vacuuming into grass bag
and convenient disposal (Fig. 28).