Boom Installation - ZKTeco PB1000 Series User Manual

4) Install screw pads and use a wrench to tighten nuts, as shown in Figure 2-3D.
5) Close the access door.
Figure 2-3A
Figure 2-3C

2.4 Boom Installation

Boom Installation Procedure
1) Take out booms.
2) Add glue onto the connection part of the boom, fix the two parts together, as shown in Figure 2-4A.
3) Remove the protection cover on the connection part, as shown in Figure 2-4B.
4) Adjust the length of the expansion boom (only for 4M and 5M device), and fasten the screw, as shown
in Figure 2-4C.
5) Install decorative cap on the expansion boom, as shown in Figure 2-4D.
6) Install the anti-crash strip, as shown in Figure 2-4E.
7) Put the boom on the ground for 30 minutes, let the glue be solid, then mount it on the cabinet, as
shown in Figure 2-4F.
Parking Barrier User Manual
5
Figure 2-3B
Figure 2-3D