Identification Unit Parts; Installation Site - S&P UVF ECOWATT Series Manual

7.2. IDENTIFICATION UNIT PARTS

The main module may consist of three different sections: fi lter, coils and fans. However, one
of the fi rst two sections may not be included. The following illustration identifi es the main
components of the main module.
Cover fi lter access
* In the small models UVF-400/160, UVF-600/200 and UVF-1100/250 the terminal box is remote, supplied with a
650mm long hose cable.

7.3. INSTALLATION SITE

The unit must be installed so that the airfl ow is upright vertical position: Bottom air intake
and top discharge.
• Avoid installing the unit in areas near heat sources or in damp areas where the unit might
come in contact with water or the relative humidity is close to 100%.
• It is recommended that the unit be installed in a place that is easily accessible for the ins-
tallation. Provide suffi cient room for maintenance, connection and drainage of condensate.
Support ceiling mounting
Technical plate and
arrow air sense
Terminal box*
Cover fan access
19