Alula RE251 Hidden Panic Install Manual

Resolution Compatibles
The RE251 Hidden Panic
system.

Features

• Hidden mounting
• 1-button arming and disarming
• Large, easy to differentiate button
• Mounts in hidden locations via VHB™ tape or screws
• Strong, reliable RF signal
• 4-6 year battery life with Panasonic™ CR2032 battery

Enrollment

• Put the control panel in program mode
Note: refer to the Honeywell control unit installation manual
• Go to Key in Programming
• Press "Add New"
• Change the key type to "1 Button"
• Select a user in the user setting
• Press Serial Number
• Press the intended button
• Wait five seconds, press the button again
• Wait five more seconds, press the button a third time
• Verify the Button Key and Loop Number
• Correlate, refer to the diagram

Battery Replacement

• Insert screwdriver to open
• Unscrew circuit board from housing
• Remove old battery and place new CR2032 battery positive side up

Pro Tips

3M VHB Tape works well if the surface is properly prepared and firm pressure is applied for over 10
seconds.

Surface Preparation

• Clean the surface
• Ensure the mounting surface temperature is above 50°F
Use the panel installation guide to verify proper system setup.
RE251 Hidden Panic
Honeywell Compatible
can arm, disarm, and generate panic signals for the security
Insert screwdriver here to open
Panic
(Loop 1)
I
Disarm
(Loop 2)
Arm
(Loop 3)