Troubleshooting - Zanussi ZDT21006FA User Manual

Hide thumbs Also See for ZDT21006FA:
Table of Contents

Advertisement

Available languages

Available languages

Follow carefully the instructions on the
packaging of the product.

TROUBLESHOOTING

If the appliance does not start or it stops during
operation, before you contact an Authorised
Service Centre, check if you can solve the problem
by yourself with the help of the information in the
table.
WARNING! Repairs not properly done
may result in serious risk to the safety
of the user. Any repairs must be
performed by qualified personnel.
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
The end indicator flashes 1 time inter-
mittently.
Acoustic signal sounds 1 time intermit-
tently.
The appliance does not drain the water.
The end indicator flashes 2 times inter-
mittently.
Acoustic signal sounds 2 times inter-
mittently.
The anti-flood device is on.
The end indicator flashes 3 times inter-
mittently.
Acoustic signal sounds 3 times inter-
mittently.
The appliance stops and starts more
times during operation.
With some problems the end indicator flashes
intermittently indicating a malfunction.
The majority of problems that can occur can
be solved without the need to contact an
Authorised Service Centre.
Possible cause and solution
Make sure that the mains plug is connected to the
mains socket.
Make sure that there is no damaged fuse in the fuse
box.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or wait for
the end of the countdown.
The appliance has started the procedure to re-
charge the resin inside the water softener. The dura-
tion of the procedure is approximately 5 minutes.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is
not too low. For this information, contact your local
water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clog-
ged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or
bends.
Close the water tap and contact an Authorised
Service Centre.
It is normal. It provides optimal cleaning results and
energy savings.
45

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents