Applying Initial Configuration Script - NEC Express5800 Series Installation Manual

Chapter 1 Installing Operating System

2.2.4 Applying Initial Configuration Script

Initial Configuration Script provides various settings for stable operation of the system. Be sure to apply the
initial configuration script according to the steps below.
See Chapter 1 (2.12.1 Processing detail of initial configuration script) for details of initial configuration script.
1. Set the ft Server Control Software Install CD to optical disk drive. After a while, the drive will be
automatically mounted.
2. Run the following command to apply initial configuration script.
# /media/FT905380/ftsys/RHEL6.5/nec_setup.sh
3. The following message appears when the configuration is applied. The system needs to be
rebooted, however, proceed to the next step.
Update done.
Finished successfully.
Please reboot your system.
4. Run the following command to unmount the media.
# umount /dev/cdrom
5. Remove the ft Server Control Software Install CD from optical disk drive.
In this section, description is based on the assumption that the optical disk drive has been
Tips
mounted automatically. If the optical disk drive is not mounted automatically depending on
your environment, mount it on the desired location manually. If the mount destination
differs, substitute it for the actual destination appropriately.
Express5800/R320c-E4, R320c-M4 Installation Guide (Linux)
2. Setting up Red Hat Enterprise Linux 6 Server
41