RUSTA Bubblemaker Manual page 4

ENG
USE (FIRST USAGE/REPLACEMENT OF CARBONIC CARTRIDGE)
1. Tilt and remove the PET bottle from the Bubblemaker. See fig. 1.
2. Hold the head of Bubblemaker and slightly rotate anticlockwise, until the house aligns
with the head, then lift the head up. See fig. 2A and 2B.
3. Remove the cup protector from the CO
more cup connecting the cylinder holder, if there is, you should remove it too. Screw
the cylinder on to the BubbleMaker head tightly with your hands and place it back on
to the Bubblemaker housing. See fig. 3A och 3B.
4. Rotate the head of the Bubblemaker until the the head aligns with the housing.
See fig. 4.
Fig. 1
Fig. 3A
4
gas cylinder head and check if there is one
2
Fig. 2A
Fig. 3B
Fig. 2B
Fig. 4