Table of Contents
Advertisement
Charging ◄◄◄
1. Switch off Explorer XT SE.
2. Explorer XT SE can be charged through the following methods:
◦ Main Supply
Plug the power cord to a 100 V to 240 V AC mains outlet. (see Installation)
•
Except for the initial charging, Explorer XT SE should be fully charged after 7 to 9 hours.
•
When the green Charging LED indicator stopped blinking (LED stays on), the battery is fully
•
charged.
◦ 14V DC Outlet
Plug Explorer XT SE to a 14 V DC outlet. A car cigarette lighter socket would be an example.
•
Use the appropriate adapter.
Note that Explorer XTSE can not be fully charged when this method is used.
•
Tip:
You can leave Explorer XTSE plugged in even after it is fully charged. Explorer XT SE uses trickle charging
method. If the cord is still plugged after the battery reached full charge, the battery will not be damaged in any
way. Trickle charging also maintains the battery's optimum life span.
When the unit is accidentally discharged in full (unit was left-on for a long time even after low battery shut down),
slight abnormality may be observed when trying to recharge the unit.
When charged, unit may falsely show that battery is full. Just repeatedly plug and unplug the unit every 30
minutes until battery recovers and the indicator starts to blink.
Explorer XT SE User's Manual | © Innovatronix Inc. | www.innovatronix.com | Revision Date: August 5, 2015
5
Advertisement
Table of Contents
