Battery Replacement - Innovatronix Tronix Explorer XTSE User Manual

Table of Contents

Advertisement

Battery Replacement ◄◄◄
Caution!
Risk of electric shock. Extreme caution should be observed at all times. Before replacing the
batteries, disconnect all cords and wait 30 minutes before proceeding with the repair. Remove all
metal objects attached to the body such as jewelry, wristwatch, and the like. Use properly insulated
tools and handles. Strictly follow the instructions to avoid further damage and injury.
1. Turn off the unit.
2. Remove the screws of the cover located on the side and top portion of the unit.
3. Carefully disconnect the battery terminals located at the boost converter.
4. Disconnect the battery cord (S cord) located in the charger board, this is to avoid short circuit.
5. Remove the charger board located at the sides of the battery.
6. Unscrew the bolts found under the battery casing.
7. Remove the battery bracket and the battery.
8. Remove the boost converter board found on the other side.
9. Remove the screws and pull out the battery out of the casing.
10. Securely place the battery by sliding it to the battery casing. Tighten the screws and reinstall the boost
converter board.
11. Turn to the other side and make sure to place the batteries inside the metal closure first.
Reinsert the battery screws and reinstall the charger board before connecting the battery terminals and
conductor.
Note: Ensure that the battery terminals do not touch the heat sink. For safety, cover the area of the heat
sink where the battery terminals will pass during battery replacement.
12. Reinsert cover and tighten all screws.
Dispose replaced batteries properly. Deliver the battery to its manufacturer for recycling or observe proper
battery disposal.
Note:
Ensure the battery terminals do not touch the heat sink. For safety, cover the area of the heat sink where the
battery terminals will pass during battery replacement.
Do not interchange the polarity of the wires. Black wire is for the negative (–) terminal and red wire is for the
positive (+) terminal.
Explorer XT SE User's Manual | © Innovatronix Inc. | www.innovatronix.com | Revision Date: August 5, 2015
7

Advertisement

Table of Contents
loading

Related Products for Innovatronix Tronix Explorer XTSE

Table of Contents