Table of Contents
Advertisement
Operation ◄◄◄
1. Ensure that the Explorer XT SE is charged according to installation instructions.
2. Set up necessary lightning equipment. Make sure that the unit is turned off.
3. On the front panel, connect the flash unit's plug to the Explorer XT SE's socket.
4. Turn on the Explorer XT SE unit by switching the power to "|" position.
The battery level indicators signals the power left on the inverter's battery.
5. The Tronix Explorer XT SE is expected to fully operate by now, supplying power to the flash units.
Note:
Using of modeling lamps in the flash units will prolong recycle time and will easily discharge the battery. Therefore, it is not
advisable to use Explorer XT SE in supplying power to modeling lights.
Below is a table of the status LEDs of Explorer XT SE and its corresponding indication:
Charging
Battery full
Battery at half power
Battery low
Aside from its normal use of powering strobes and flashes, the battery of Explorer XT SE will be discharged if
any of the following occurs:
Explorer XTSE is switched on at no load. The battery of Explorer XT SE will be discharged after
•
~ 7 hours.
Explorer XTSE is switched off at no load. The battery of Explorer XT SE will be discharged after 200
•
days. Thus, when not in use, it is recommended that Explorer XT SE should be plugged in to a 100 V to
240 V AC mains outlet or to a 14 V DC outlet.
Even when switched off, the internal circuit of Explorer XT SE still consumes power.
•
A totally discharged battery will severely affect its useful life.
Should Explorer XT SE run out of power and no power source is present, the Tronix Auxiliary Battery Pack can be connected
to Explorer XT SE. When the Auxiliary Battery Pack is connected, Explorer XTSE bypasses its internal battery and draws
power from the battery pack. Tronix Auxiliary Battery Pack is sold separately. More information can be obtained from the
Innovatronix website (see Contact Information).
Explorer XT SE User's Manual | © Innovatronix Inc. | www.innovatronix.com | Revision Date: August 5, 2015
Status
Green Charging LED indicator is blinking
Green High LED indicator is lit
Yellow Mid LED indicator is lit
Red Low LED indicator is lit
Indication
4
Advertisement
Table of Contents
