Operating The Appliance; Switching The Hob On And Off; Setting A Hotplate - Siemens EX9 LX Series Instruction Manual

1Operating the appliance

T his chapter explains how to set a hotplate. The table
O p e r a t i n g t h e a p p l i a n c e
shows heat settings and cooking times for various
meals.

Switching the hob on and off

Use the main switch to switch the hob on and off.
When you first switch on the appliance, you will be
prompted to set up your home network. The
will be lit dimly for a few seconds on the display panel.
To begin setting up the connection, touch the
D sensor and proceed in accordance with the
information given in the section entitled ~ "Home
Connect".To exit initial set-up, touch any sensor.
To switch the hob on and off, touch the
audible signal will sound. The symbols for the cooking
zones and the functions available at this time will light
up.The hob is ready to use.
To switch the hob off, touch and hold the
until all indicators go out. The residual heat indicator will
remain lit until the cooking zones have cooled down
sufficiently.
Notes
If the appliance has not been connected to your
■
home network or the connection has been broken,
network connection initial set-up will be activated
whenever you switch on the hob.
The hob will automatically switch itself off if the
■
cooking zones have been switched off for a few
seconds.
The settings are stored for 4 seconds after the hob
■
has been switched off. If you switch the hob back on
during this time, the hob will operate using the
stored settings.

Setting a hotplate

Set the desired heat setting in the settings area.
Heat setting 1 = lowest setting.
Heat setting 9 = highest setting.
Every heat setting has an intermediate setting. This is
marked with † .
The left-hand hotplates are set in the settings
Note:
area on the left and the right-hand and central hotplates
are set in the settings area on the right.
Notes
To protect the fragile parts of your appliance from
■
overheating and electrical overloading, the hob may
temporarily reduce the power.
In order to prevent the appliance from producing
■
excess noise, the hob may temporarily reduce the
power.
Selecting a hotplate and heat setting
The hob must be switched on.
1.
2.
symbol
D
symbol. An
#
The heat setting is set.
Changing the power level
symbol
#
Select the hotplate and set the desired power level in
the programming zone.
Switch off the hotplate
Select the hotplate and set it to
panel. The hotplate turns off and the residual heat
indicator appears.
Notes
■
■
Operating the appliance
Touch the and symbols for the required
" Ä
hotplate.
The indicator gets brighter.
‹
Swipe your finger over the relative settings area until
the required heat setting lights up.
If no pan has been placed on the hotplate, the
selected power level flashes. After a certain time has
elapsed, the hotplate switches off.
If a pan has been placed on the hotplate before
switching on the hob, it will be detected within
20 seconds of pressing the main switch and the
hotplate will be selected automatically. Once
detected, select the power level within the next
20 seconds or the hotplate will switch off.
en
in the programming
‹
11