Eaton K1121V3 Instruction Leaflet

Instruction Leaflet K1121V3
Leat
Product luminaires comply with EN60598 and are suitable for use in normal interior conditions.

This luminaire has an ambient temperature range of -10 C to 25 C for the non-emergency version

For Emergency variants - This luminaire has an ambient temperature range of 5 C to 25 C, to ensure the batteries work correctly

1
Recessed - Bracket Installation
Aperture
Trim - 65.5mm wide
Trimless - 57.0mm wide
a)
Recommended Wooden Batten Spacing
44x44mm
Wooden
Battens
Drilling Direction
Cut aperture to required size.
Using the flat bracket (sold separately) as a drilling template, drill 4 x holes
5mm dia, through pilot holes. See 'Bracket Orientation'.
Counter sink the drilled holes so c/sk screws (supplied) sit flush with
the plasterboard.
c)
o o
For Plasterboard Support
240mm MAX
Plasterboard
160mm MIN
Drilling Direction
Fold flat bracket over and fix spring clip.
Fit main bracket into slider brackets. Ensure that
dimension 'a' from bottom of plasterboard to the inside
face of main face is adhered to. Tighten slider
bracket screws to hold main bracket in place.
July 2018
o o
Fixing crs
Bracket Orientation
When using the flat bracket for the drill hole locations make sure the metalwork is
in the correct orientation.
The image on the left shows the orientation for the trimless variant and the image on
the right shows the orientation for the trimmed version.
b)
Fixing Centres (per fitting)
700mm
1.0m
1.5m 1200mm
2.0m 1700mm
2700mm + centre fixing
3.0m
Secure each slider to
plasterboard using M5
c/sk screws supplied
IMPORTANT: Once brackets
are fully installed. Plaster surface
before installing the Leat.
Dim 'a'
Trimmed 79.0mm
Trimless
76.0mm