Some pets are sensitive to contact pressure. You may find after some time that your pet is very tolerant of the collar. If so you Petainer CUSTOMER SERVICE..............19 may relax some of these precautions, it is important to continue daily checks of the contact area.
How the dog training system works? Components This system has been proven safe, comfortable, and effective for all pets over 15Ibs, it assists you in controlling your pet without a leash in a range up to 300m, At the push of a button, the remote transmitter sends a signal, activating the collar -receiver.
Key Definitions Light Mode: Under this mode, when “Y” button is pressed the green LED light the receiver will flash every one sec, rendering it convenient to locate your pet: Remote Transmitter (esp. in the dark). ½ button indicates channel 1 or 2 on the transmitter, select one channel for use with one collar-receiver.
4. Charging Hole: for collar-receiver charging. How to use the remote transmitter 1.To turn on/off the transmitter, press any button on the transmitter. 2. Press the MODE button to toggle among 4 different modes 3. Press UP/DOWN buttons on the light hand side of the transmitter to adjust the intensity level of vibration or static shock.
Sync transmitter with collar-receiver: Test the static shock function (Figure 2-1) 1. Power on the remote transmitter by pressing any button on the Put the test-light on the contact points of the collar-receiver. Turn on transmitter. the remote transmitter, switch to SHOCK mode and press the UP/DOWN 2 Select channel 1 or 2.
Fit the collar-receiver the “Y” button again to send the signal from the remote to the collar receiver. This applies to all functions. Important: The proper fit and placement of the collar-receiver is essential for effective training. The metal contact probes must have direct contact Test the LED light function (Figure 2-4) with your dog's skin as follows: Turn on the remote transmitter, switch to LED LIGHT mode.
Frequently Asked Questions: We suggest you give the dog VIBRATION before starting the STATIC SHOCK. After a time of training, the dog will learn that shock will How old does a pet have to be before using the system? come after vibration. In this way, the vibration alone can effectively curb the misbehaviors of your dog.
Troubleshooting Can I attach a leash to the collar-receiver? No. This can result in pulling the metal probes too tightly against your dog's neck. My pet is not responding after the Petrainer pet training system has Attach a leash to a separate, nonmetallic collar or a harness, ensuring the extra been installed successfully.
I want to test the collar-receiver on myself, but it does not work. (11) If you know a particular misbehavior your dog does, then reinvent this situation during a training session. You will have far more success if you deal with one When testing the receiver on your hands, please touch the 2 electrodes at the misbehavior at a time in a controlled situation.
Addendum and Upgrading Notes: 1. Please note that when shaking the receiver you may hear a rattling noise, which is actually caused by the built-in vibration sensor and is by no means an indication of any malfunction in the receiver 2.