Safety Notes; Explanation Of Symbols; General Power Tool Safety Warnings; Work Area Safety - Bosch UniversalHedgePole 18 Original Instructions Manual

OBJ_BUCH-3416-001.book Page 3 Friday, September 29, 2017 8:09 AM
English

Safety Notes

Explanation of symbols

General hazard safety alert.
Read instruction manual.
Do not use the machine in the rain or leave it
outdoors when it is raining.
Pay attention that bystanders are not injured
through foreign objects thrown from the ma-
chine.
Warning: Keep a safe distance from the machine
when operating.
Always wear gloves and safety goggles. Further
protective equipment such as non-skid safety shoes and a
hard hat is recommended. Adequate protective clothing will
reduce personal injury by falling branches and accidental
contact with the cutting blade.
Never touch power supply or
telephone lines. These lines conduct
high voltage and there is severe danger
of electric shock. Keep a minimum
distance of 10 m.
Warning: Bystanders should keep a safe distance from the
machine when operating.

General Power Tool Safety Warnings

Read all safety warnings, instructions,
WARNING
illustrations and specifications
provided with this power tool. Failure to follow all
instructions listed below may result in electric shock, fire
and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
Bosch Power Tools

Work area safety

 Keep work area clean and well lit. Cluttered or dark areas
invite accidents.
 Do not operate power tools in explosive atmospheres,
such as in the presence of flammable liquids, gases or
dust. Power tools create sparks which may ignite the dust
or fumes.
 Keep children and bystanders away while operating a
power tool. Distractions can cause you to lose control.
Electrical safety
 Power tool plugs must match the outlet. Never modify
the plug in any way. Do not use any adapter plugs with
earthed (grounded) power tools. Unmodified plugs and
matching outlets will reduce risk of electric shock.
 Avoid body contact with earthed or grounded surfaces,
such as pipes, radiators, ranges and refrigerators.
There is an increased risk of electric shock if your body is
earthed or grounded.
 Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of electric
shock.
 Do not abuse the cord. Never use the cord for carrying,
pulling or unplugging the power tool. Keep cord away
from heat, oil, sharp edges and moving parts. Damaged
or entangled cords increase the risk of electric shock.
 When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of electric shock.
 If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of
electric shock.
Personal safety
 Stay alert, watch what you are doing and use common
sense when operating a power tool. Do not use a power
tool while you are tired or under the influence of drugs,
alcohol or medication. A moment of inattention while
operating power tools may result in serious personal
injury.
 Use personal protective equipment. Always wear eye
protection. Protective equipment such as dust mask,
non-skid safety shoes, hard hat, or hearing protection
used for appropriate conditions will reduce personal
injuries.
 Prevent unintentional starting. Ensure the switch is in
the off-position before connecting to power source
and/or battery pack, picking up or carrying the tool.
Carrying power tools with your finger on the switch or
energising power tools that have the switch on invites
accidents.
 Remove any adjusting key or wrench before turning
the power tool on. A wrench or a key left attached to a
rotating part of the power tool may result in personal
injury.
English | 3
F 016 L81 578 | (29.9.17)