Taymor CALEDONIA 06-4091HS Installation Instructions

INSTALLATION INSTRUCTIONS
CALEDONIA 06-4091HS / 06-4091HSSN
ROMAN TUB FAUCET
THIS FAUCET MEETS OR EXCEEDS THE FOLLOWING STANDARDS:
ASME A112.18.1/CSA B125.1 and NSF-61
THANK YOU FOR PURCHASING THIS TAYMOR PRODUCT. ALL TAYMOR PRODUCTS ARE CAREFULLY
ENGINEERED AND FACTORY TESTED TO PROVIDE LONG TROUBLE-FREE USE UNDER NORMAL CONDITIONS.
HAVE BASIC TOOLS READY
1
RECOMMENDED TOOLS:
Teflon tape Screwdrivers Adjustable
Flashlight
wrench and
pipe wrench
WARNING: READ ALL the instructions completely before beginning.
READ ALL warnings, care and maintenance information.
Taymor recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and provincial plumbing and building codes.
Need Help? Please call our toll-free Customer Support line at
(WEST) 1-800-267-4774 (EAST ) 1-800-387-7064 for additional assistance or service.
TURN OFF THE MAIN WATER SUPPLY
2
Locate water supply inlets and shut off water supply valves.
These are usually found near water meter.
DECK PREPARATION
3
Drill holes in FINISHED DECK per diagram.
NOTE: This kit is intended for installation up to 1-1/4" thick.
Ø1-3/8"
(35mm)
INSTALL THE VALVE SYSTEM
4
A
Remove flange (1) from housing assembly.
1
1
C
Place a flange on each housing assembly.
Thread each flange down. Adjust each lower
locknut and washer. Wrench tighten locknuts.
TORQUE
11 - 15 FT/LBS.
TORQUE
11 - 15 FT/LBS.
Your installation may require new supply
lines. (Supply lines are not included.)
Torque wrench Safety goggles Plumber's putty
TURN OFF
TURN OFF
Ø1-1/8"
(29mm)
Ø1-3/8"
(35mm)
Ø1-3/8"
(35mm)
B
With the housing assembly marked "HOT" on
the left, insert the housing assembly through
the mounting holes from the underside of the
deck/rim.
D
Place a handle flange on each housing
assembly. Thread each handle flange down.
HANDLE INSTALLATION
5
Install handles (1) and tighten the set screw (2).
Silicone caulk
DIVERTER INSTALLATION
6
A
Remove lift rod knob (1) and remove set
screw (2).
C
Remove connector (1) from diverter body (2).
2
SPOUT INSTALLATION
7
Assemble and align spout (1) onto diverter body and tighten set screw (2). Insert index
(5). Place lift rod knob (3) onto lift rod (4) and hand tighten.
CUSTOMER SERVICE WEST 1-800-267-4774 | EAST 1-800-387-7064 | taymor.com
1
2
B
Remove spout (1) from diverter body (2).
1
1
2
2
D
From underneath the deck, insert diverter
body with rubber washer (1), metal washer
(2) and mounting nut (3) through center hole.
From above, thread connector (4) onto di-
1
verter body. Tighten mounting nut (3), so that
the connector (4) sits flush to the surface of
working area.
1
2
3
TORQUE
11 - 15 FT/LBS.
3
1
5
2
4
® REGISTERED TRADEMARK OF TAYMOR INDUSTRIES LTD.
4