Jaco Ultralite 200 Series Quick Start Manual page 13

Once the work surface is opened, you will see the battery and cable management bay as shown below. The laptop
power brick should be installed first and plugged into the power cube also shown below. The power brick for the
battery pack will already be installed in the cable management area. Next, install the battery as shown. The two
flanges may need to be loosened using a Phillips Head screw driver. Position the battery so that the status read
out is in the lower right corner. Tighten the two clamps to secure the battery in place.
Next, plug the Charging Cable into the battery pack as shown and rout the Output Cable out the back of the Top
assembly and up through the VESA Stand. Plug the Output Cable connector into the DC power port on the monitor
as shown below.
Once this is complete, place your laptop on top of the battery pack, leaving room so that the status read out on the
battery pack can be seen, as shown in red below. Connect your laptop power cable. If you want to lock your
laptop into the Cart top assembly, use the Kensington cable lock that is integrated into the Cart top. This is located
in the top right corner of the Cart as shown below.
12