Lint Filter; Dispenser Drawer - Electrolux LI22Y Quick Manual

Table of Contents

Advertisement

Available languages

Available languages

CLEANING AND MAINTENANCE

Lint Filter

The lint fi lter function is to retain the eliminated
lint from clothes during washing. To preserving
and effi ciency of this fi lter is recommended
clean it after each washing cycle.
2A
1A
1B
For models with agitator: turn and pull the
lid of the agitator upwards (1A). press the side
locks (2A) to remove the fi lter. Wash the fi lter in
water and, if necessary, use a small brush (3A)
that does not damage the mesh fi lter. place the
fi lter on its housing, ensuring that it is properly
positioned. place the lid in the agitator and
attach it until the end.
For models with impeller: pull the fi lter through
the upper latch (1B) until the disconnection.
Then pull (2B) upwards to remove the bracket.
To open the inner fi lter, press (3B) the side lock,
and rotate (4B) the inner fi lter, allowing internal
and external cleaning.
Wash with running water and, if necessary, use
a brush that does not damage the fi lter mesh.
To replace, rotate the inner fi lter to catch again,
and replace the fi lter holder, making sure it is
properly seated.
The accumulation of lint in the fi lter can cause
the clogging in the mesh. To clean the fi lter,
use only running water. Do not use cleaners
or brushes which can damage the fi lter mesh.
During washing of colored clothing, the
release of dyes can occur, dyeing the fi lter
mesh.
3A
4B
2B
3B
Internal Part
Clean the inside of the washing machine at
least once a month. put 1 liter of bleach in the
drum. Select the High water level and the Stain
Removal program. Let the washing machine
complete the cycle to ensure the complete
removal of bleach.
This cleaning should be done to prevent spots
in clothes, caused by accumulated waste in the
washing machine due to excessive use of soap
and softener.
Water Filter
Close the water inlet. disconnect the end of
the hose from the faucet and remove the fi lter.
Clean the fi lter with a fl ush of water. If you
have diffi culties when removing the impurities,
use a small soft brush. This procedure should
be done periodically to prevent the fi lter
clogging. If the fi lter is damaged and needs to
be changed, call Frigidaire Service Center. Do
not forget to replace the fi lter in the hose and
open the faucet again. The machine should
not be used without the fi lter under the risk of
damage the product.

Dispenser Drawer

To clean the dispenser, proceed as follows:
1
3
1. open the drawer completely.
2. To remove, push the drawer up so that the
drawer bolts clear the rails, allowing the
drawer to be removed.
3. If necessary, the inside can be cleaned using
a small brush.
The pieces of the drawer can be cleaned using
water, soap, a cloth or a brush to remove small
wastes.
2
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Li17yL20yLc12Li13yL16yL16c ... Show all

Table of Contents