Busy Channel Lockout (Bcl) - Kenwood NX-1000 Series User Manual

BUSY CHANNEL LOCKOUT (BCL)

If BCL is set up by your dealer, you will be unable to transmit on the channel if it
is already in use. Under these circumstances, use a different channel or wait until
the channel becomes free. However, if BCL Override has also been programmed,
you can transmit over the current signal:
1 Press and hold the PTT switch.
• If the channel is already in use, a warning tone will sound.
2 Release the PTT switch, then press and hold the PTT switch again within half
a second.
3
Speak to the microphone as you would during a normal call.
The transceiver transmits according to the configuration in Busy Channel Lockout
by dealer.
In Analog System
Carrier Only
Incorrect Tone
Optional
Signaling
In NXDN System
Carrier Only
Incorrect RAN
Correct RAN
Any RAN
In DMR System
Carrier Only
Correct CC
The transceiver cannot transmit when carrier is received.
The transceiver cannot transmit when the selected channel
is busy and QT/DQT is unmatched.
The transceiver cannot transmit when the selected channel
is busy before valid Optional Signaling matches or when the
selected channel is busy and the programmed QT/DQT is
not detected before valid Optional Signaling matches.
The transceiver cannot transmit when carrier is received.
The transceiver cannot transmit when the received RAN
and the RAN set in the channel is unmatched.
The transceiver cannot transmit when the received RAN
and the RAN set in the channel are matched.
The transceiver cannot transmit while receiving RAN
regardless of whether or not it matches with the RAN set in
the channel.
The transceiver cannot transmit when carrier is received.
The transceiver cannot transmit when the received Color
Code and the Color Code set in the channel are matched.
81