Kenwood NX-1000 Series User Manual page 38

Individual + Status
Allows you to specify a Unit ID to send status messages.
1 PF Button:
Press the programmed button to enter Individual Call Mode
(NXDN/ DMR) or Selcall Mode (FleetSync/ MDC-1200/ 5-tone).
Menu Mode:
Call Mode (NXDN/ DMR) or Selcall Mode (FleetSync/ MDC-1200/ 5-tone).
2 Press the [ <B ] and [ C> ] buttons to select a Unit ID/ name from the list.
3 Press the [ S ] button to enter Status Mode.
4 Press the [ <B ] and [ C> ] buttons to select the status messages you want to
transmit.
5 Press the PTT switch or Side 2 button to send status messages.
Lone Worker [Analog/ NXDN/ DMR]
Using Lone Worker function, the transceiver can automatically enter Emergency
Mode and notify the base station of the emergency status when the transceiver
becomes disabled from operating due to an accident.
PF Button:
Press the programmed button to change the Lone Worker On.
• Beep A (1 beep) sounds.
Press this button again to change the Lone Worker Off.
• Beep B (2 beeps) sounds.
Menu Mode:
Select "L-WK" and press the [ S ] button to change the Lone Worker On or Off.
• Lone Worker is turn On, "L-WK ON" is displayed for 1 second.
• If transceiver is on the Lone Worker mode, Lone Worker is turn Off, "L-WK
OFF" is displayed for 1 second.
On the Lone Worker mode, Lone Worker Interval time(r) will be counting down.
When you presses any button to indicate that you are safe and the timer will be
restarted.
The transceiver automatically enters Emergency Mode if you do not operate the
transceiver during the Lone Worker Interval time.
[Analog/ NXDN/ DMR]
Select "IND STAT" and press the [ S ] button to enter Individual
38