Philips VR969/05 Operating Manual page 42

View mode
You can view the picture from an external unit connec-
ted to the socket u of your video recorder on
the picture screen (monitor) of a TV set. The external
unit can be, for example, a second video recorder,
a decoder or a satellite receiver.
• If the external unit transmits a control signal, this is
recognized by the video recorder and it switches
automatically to the view mode.
You can switch the view mode on and off with the
a button.
Notes:
* If the programme position "E1" or "E2" is
selected, the video recorder cannot switch in the
view mode. This also applies for programme posi-
tions with activated decoder function.
* This function is only possible if the TV set is
equipped for it and a Scart cable is used for the
connection.
The TV monitor function
Press the a button to switch the TV set to
the "AV" (= Audio/Video input) programme position.
This is useful if you wish to monitor a "running"
recording on the picture screen (monitor) of your TV
set. For this, the video recorder must be switched on.
The video recorder display indicates briefly
"VCR MON".
A further pressure on the same button switches the
monitor function off. The video recorder display indi-
cates briefly "TV MON".
Notes:
* The monitor function is only possible if the TV
set is equipped for it and a Scart cable is used for
the connection.
* During playback, the a button has no
function.
42
Switching between VCR 1 and VCR 2
This function is very useful if you have two video
recorders operating with the same remote control
code. So that you always control the "right" video
recorder, you simply change the remote control code
of this recoder and of this remote control handset.
!
Switch on the TV set and select the programme
position intended for the video recorder.
"
Press the S button on the video
recorder.
The OSD page "INSTALLATION MENU" appears
on the picture screen.
¤
Select the option "Special settings".
Confirm with the G button.
$
The OSD page "SPECIAL SETTINGS" appears on
the picture screen.
%
Select the option "VCR Address".
On the picture screen appears the message
"To change – alter remote control code first".
&
Press simultaneously the numeric button "
and the B button .
The code of the remote control is changed.
To undo the change, press the numeric button !
and the B button.
/
Point the remote control at the video recorder and
press any button (e.g. r) button on the
remote control. The "new" remote control code is
sent to the video recorder. In the OSD page
appears the indication "VCR2".
The code of the video recorder is also changed.
SPECIAL SETTINGS
Channel/Frequency
16 :9
VCR adress
Y/C CVBS input/output
Beeper
To change - alter remote
control code first
(
Complete the setting by pressing the button
l twice.
CHAN
on
VCR1
on
Exit - MENU