Normal Timer Programming - Philips VR969/05 Operating Manual

TIMER Programming (Standard Timer)
Data on six recordings can be entered and stored in
the video recorder. The OSD page on screen or the
video recorder display will lead you "step by step" to
the next and possible data entry.
The data is stored in the next free TIMER block of the
video recorder.
You can programme with the buttons on the video
recorder and/or on the remote control handset.
Ensure that a cassette without erase protection is
inserted.
!
Switch on the TV set and select the programme
number for the video recorder.
"
Press the remote control button o. The
OSD page "TIMER" appears on screen.
¤
Select the line "Standard Timer". Confirm this by
pressing the button _.
$
The OSD page "TIMER" appears on screen.
The following appears in the insert line:
"today´s" date, the current time as a start time and
the current time plus "1:30 hours" as an end time.
TIMER
Date Prog
01 – –
once
D daily
W weekly
/ /D/W - SELECT
%
If you wish to programme daily or weekly
recordings, select the line "daily" or "weekly" using
the button p.
Either "D" or "W" also appears beside the date.
Daily recordings can only be programmed for the
weekdays Monday to Friday.
&
Enter the data using the digit buttons k, or
confirm the date by pressing the button _.
Start End
20:15 21:45
Confirm - OK
/
If you wish "subtitles" to be recorded also, press
the p button. Enter the number of the
subtitles page as three digits with the numeric
buttons O.
(
Enter the number of the TV programme using the
digit buttons k.
)
The "PDC" function can be switched off and back
on again by pressing the button p.
<:
Enter the start time using the digit buttons k.
<>
Enter the end time where necessary.
<Y
When you have entered all data correctly, press
K.
the button
"Timer ready" appears briefly in the screen display.
The symbol " " appears in the video recorder display. It
indicates that a TIMER has been programmed.
If you wish to programme additional settings, repeat
" <Y
Steps – .
<X
Terminate programming with the d
button.
Some important information:
* If "SET CLOCK" appears in the display, the inter-
nal clock of the video recorder has not been set.
Set the clock.
* Daily recordings can only be programmed for the
weekdays Monday to Friday.
* In the case of "daily/weekly" programming, the
first recording must take place within the first
week.
* The "TIMER" menu appears straight after Step
if you have set the display "Standard Timer" on the
OSD page "PERSONAL PREFERENCES".
%
(See Step of the section "Personal preferences"
in Chapter 8).
"
23