Advertisement
8.
Place two ball bearings into bearing tube.
9. Insert a main shaft to endbell.
10. Put a c-clip to the slot of main shaft.
11. Place three screws at the end-bell.
Komodo Hobby
www.komodohobby.com
Insert a main shaft to endbell
Install wound stator inside the bell and
put a C-clip to the slot of main shaft to
secure whole motor system.
Place three M3 x 4 screws to end bell to secure
the position of main shaft. Each screw must be
turned a bit each time until all screws tighten up.
9
Advertisement
