Charging - Panasonic EW1411 Operating Instructions Manual

Parts identification
Front Back
Main unit
Nozzle release button
Power switch [0/1]
Mode switch
Mode indicator
Charging indicator
Ventilation hole
Suction hose
Filter
Water tank
Water tank cap
Charger (RE8-53)
Charging section
Cord
Note
There may be moisture inside the main unit (water tank and
suction hose) left from the distilled water used for product testing.
8
Power plug
Nozzle stands
Screw holes for wall mounting
The charger can be mounted
on a wall using two wood
screws.
Nozzle (x2)
Nozzle
Identification ring
Nozzle handle
Accessories
2 screws

Charging

On the bathroom countertop or a shelf
1. Place the cord in the right, left or centre
cord guide, depending on where the charger
will be placed.
2. Place the charger on a secure, level surface.
3. Plug in the power plug.
1
1
Insert main unit so it stands
upright in the charging section.
The charging indicator will light up.
• Be sure to place the main unit upright. If
the main unit is tilted or not in direct contact
with the charger, the main unit may not
charge properly.
• Charging is completed in about 15 hours.
• The lamp does not go off even when
charging ends.
• The main unit will provide an operation time
of approximately 15 minutes of use when
the battery is fully charged. (The operating
duration will become shorter as the
batteries get older.)
2
2 Disconnect the power plug after charging is
completed.
• The battery performance will not be affected even if it is
charged for more than 15 hours.