Page 1
Additional manuals are available from your WELLS DEALER. THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment.
Page 2
Wells’ discretion have the parts replaced or codes, including incorrect gas or electrical connection. Wells is not liable repaired by Wells or a Wells-authorized service agency.
PARTS & SERVICE CUSTOMER SERVICE DATA INTRODUCTION Thank You for purchasing this Wells Manufacturing appliance. Proper installation, professional operation and consistent maintenance of this equipment will ensure that it gives you the very best performance and a long, economical service life.
FEATURES & OPERATING CONTROLS ELEMENT SUPPORT DRIP PAN HEATING ELEMENT HEATING ELEMENT (LIFTED / ROTATED) TEMPERATURE CONTROLS POWER CORD INDICATOR LIGHT ADJUSTABLE LEGS IL2818 NAME PLATE Provides heat for food preparation Heating Element Coil-type elements rotate for access to drip pan Note: Solid (french plate) elements on model H-70 do not lift Element Support* Holds coil-type element in proper position...
PRECAUTIONS AND GENERAL INFORMATION This appliance is intended for use in commercial establishments only. WARNING: This appliance is intended to prepare food for human consumption. ELECTRIC No other use is recommended or authorized by the manufacturer or its SHOCK HAZARD agents.
INSTALLATION UNPACKING & INSPECTION NOTE: DO NOT discard the carton or other packing Carefully remove the hotplate from the carton. Remove all protective materials until you have plastic film, packing materials and accessories from the hotplate inspected the appliance for before plugging the hotplate into electrical power or otherwise hidden damage and tested it performing any installation procedure.
OPERATION GENERAL OPERATIONAL NOTES CAUTION: Carefully read the description of the hotplate operation on the HOT SURFACE specification sheet. Exposed surfaces can be hot DO NOT attempt to perform any maintenance or service unless the to the touch and may cause hotplate is disconnected from electrical power.
CLEANING INSTRUCTIONS PREPARATION CAUTION: ELECTRIC Unplug or disconnect hotplate from electrical power before cleaning. SHOCK HAZARD Allow hotplate to cool completely before cleaning. Disconnect hotplate from electric power before FREQUENCY cleaning. Daily TOOLS CAUTION: Plastic Spatula and Plastic Scouring Pad BURN HAZARD Clean Cloth or Sponge Mild Detergent or Cleaner Formulated for Stainless Steel...
Damaged temperature control, Contact Authorized Wells Service element or other internal component Agency for repairs NOTE: There are no user serviceable components in this appliance. In all cases of damage or component malfunction, contact your Authorized Wells Service Agency for repairs.
Page 10
EXPLODED VIEW: H33 H-33 COUNTERTOP ELECTRIC HOTPLATE - 115V - SPIRAL ELEMENT (Canadian only) WELLS Model: H33 Countertop Electric Hotplate - 115V - Spiral Element IL1747 Rev. A 4/24/09 PL221...
Page 11
Part No Description 2N-30514ELUL ELEMENT 120V 1500WW H33 2D-30514DT DRIP TRAY H115 & H33 I7-30514CR ASSY CLIPS & RING H115 & H33 2C-33977 SCREW 8-32X3/8 PH BND HD 2C-300243 SCREW 10-32X1/4 PH BND HD I7-43370 COVER TERM H33 115 CSA...
Page 12
EXPLODED VIEW: H63 H-63 COUNTERTOP ELECTRIC HOTPLATE - 208/240V - SPIRAL ELEMENT HOTPLATE W/CORD ONLY REAR FRONT Model: H63 Countertop Electric Hotplate - 208/240V - Spiral Element IL1748 Rev. B 1/18/10 PL221...
Page 13
PARTS LIST: H63 H63 COUNTERTOP ELECTRIC HOTPLATE Fig No Part No Description 2N-30293ELUL ELEMENT 240V 260W H63 I7-30293CR ASSY CLIPS & TRIM RING H- 2D-30293DT DRIP TRAY H-63 2C-33977 SCREW 8-32X3/8 PH BND HD WS-50131 TERM BLOCK KIT (RETRO 301) 2C-35736 NUT 8-32 HEX KEPS MS GREEN 2C-41974...
Page 14
EXPLODED VIEW: H65 H-65 COUNTERTOP ELECTRIC HOTPLATE - 208/240V - SPIRAL ELEMENT REAR FRONT Model: H65 Countertop Electric Hotplate - 208/240V - Spiral Element IL1749 Rev. A 4/24/09 PL221...
Page 15
PARTS LIST: H65 H65 COUNTERTOP ELECTRIC HOTPLATE 208/240V Fig No Part No Description 2N-30293ELUL ELEMENT 240V 2600W I7-30293CR ASSY CLIPS & TRIM RING 2D-30293DT DRIP TRAY 2C-33977 SCREW 8-32X3/8 PH BND HD 2C-54285 SCREW 8-32X3/8 PH 100 FL 2C-41974 NUT 8-32 HEX 7/8 LONG ALU 2C-35736 NUT 8-32 HEX KEPS MS GREEN WS-50131...
Page 16
EXPLODED VIEW: H70 H-70 COUNTERTOP ELECTRIC HOTPLATE - 208/240V - SOLID (FRENCH PLATE) ELEMENT REAR FRONT Model: H70 Countertop Electric Hotplate - 208/240V - French Plate IL1750 Rev. B 8/20/09 PL221...
Page 17
PARTS LIST: H70 H70 COUNTERTOP ELECTRIC HOTPLATE 208/240V Fig No Part No Description WS-503973 ELEM HOTPLATE UPGRADE FUSED 2C-41974 NUT 8-32 HEX 7/8 LONG ALU 2C-35736 NUT 8-32 HEX KEPS MS GREEN WS-50131 TERM BLOCK KIT (RETRO 301) 2C-34285 SCREW 8-32X3/8 PH 2R-Y5092 FEET ADJ 4GRAY 3/8-16 2J-30516...
Page 18
EXPLODED VIEW: H115 H-115 COUNTERTOP ELECTRIC HOTPLATE - 120V - SPIRAL ELEMENT REAR REAR FRONT FRONT Model: H115 Countertop Electric Hotplate - 120V - Spiral Element IL1751 Rev. B 7/15/13 PL221...
Page 19
PARTS LIST: H115 H115 COUNTERTOP ELECTRIC HOTPLATE 120V Fig No Part No Description 2C-33977 SCREW 8-32X3/8 PH BND HD 2N-33573ELUL ELEMENT 120V 825W H115 2D-30514DT DRIP TRAY I7-30514CR ASSY CLIPS & RING 2C-33935 SCREW 6ABX5/16 PH PAN SMS 2R-30584 KNOB RR HP91 2R-30583 KNOB ASSY FRONT HOTPLATE 2C-31697...
2R-Y5092 For factory authorized service, or to order factory authorized 4” Legs, Die Cast Set of 4 WS-20563 replacement parts, contact your Wells authorized service agency, or call: Drip Tray, 8” for H-63, H-65 I7-30292 Wells Manufacturing 265 Hobson Street Smithville, Tennessee 37166 U.S.A.